Video Transcript for What to Know About the Phoenix Faucets RV Bathroom Vessel Sink Faucet

Hi everybody, Andy here with etrailer.com and today we're gonna take a look at this Phoenix Faucets RV bathroom vessel sink faucet. This faucet is going to let you upgrade the bathroom vessel sink faucet in your RV or camper. And this is going to be a very simple installation, you're going to just drop the new faucet in place through the mounting hole of your existing faucet and then tighten down the included mounting hardware. And they provide this really great handy tool to help you tighten down the hardware. So hopefully, as you can see right here, you can see these posts here and then the hardware and then you just slide this tool up the post and then that's going to allow you to tighten that hardware. So it's going going to be a very easy, very simple installation and it's great that they include this tool with this faucet.

And then finally, you just need to connect the included hot and cold water lines. The use of tub and tire caulk may be required, depending on your particular insulation but that caulk is not included with this faucet. Now this features a single handle design with a lever-style handle and the ceramic disc cartridge is maintenance free and the durable long-lasting disc creates a watertight seal when the faucet is closed. This does have a flow rate of 1.2 gallons per minute. It is WaterSense certified and this high rise spout is tall enough to clear your vessel sink edge.

The distance from the countertop that this will be installed on to the aerator is right at 3 1/4 inches. Now you can add a matching pop-up drain and lift rod assembly. Of course that is sold separately, but if you wanted to install that you would just need to pull this rubber plug out and then you can just install that pop-up drain and lift rod assembly. So the functionality is available if you want to do that. Now this is of a durable zinc and zinc alloy construction with this chrome finish.

This chrome finish looks pretty sharp. I do want to point out though, that it does pick up fingerprints and smudges quite easily, so just be aware of that. You're going to be wiping this down quite a bit just to keep those smudges off. But we do also provide this in two other finishes. We have this in a matte black finish, which is pretty stylish, then also my favorite finish, brushed nickel.

And so if you are are interested in something other than chrome, you can find the matte black and the brushed nickel finish here on our website at etrailer.com. Now, I took some measurements of this faucet before our time together just so you can be sure that this is going to work for you. The overall height from the top of our faucet to the countertop that this will be installed on, we're sitting right at about 6 5/8 inches tall. The width of our base, we are sitting right at 6 3/8 inches wide and then the depth is 2 3/8 inches. And in regards to the spout length, I measured from the center of our faucet to the end of our spout and we we're sitting at almost 5 inches, right at 4 7/8 inches on that spout length. The water supply line size is half an inch male pipe thread. And this does include instructions to walk you through the very simple insulation process. Overall, I am very impressed with the build quality of this faucet. Obviously I do not have this connected to water but it was a very simple installation installing this on my demonstration table. So once you get this faucet, installation is going to be very quick and very easy and then you will be ready to go. Well, that's gonna conclude our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.